Please note: Whenever the term ‘normal’ is used in the Troubleshooting Guide, it refers to the proper operating condition of that device or indicator.

After correctly connecting all the system components, indications of the normal operating condition of the LBV System is as follows:

• Upon energizing the SPS Main Power Switch, The SPS Red and Amber LEDs are continuously lit, and do not flash. The LBV is not energized, and the system does not output video.
• Upon pressing the CC Power Button, a soft click can be heard from the SPS, the SPS Red LED remains lit, and the SPS Amber LED begins a continuous cycle of being lit and unlit for ~2 seconds in each state. The CC power LED is continuously lit, and the CC Auto Head and Auto Depth LEDs remain unlit.
• A color video image appears on the monitor (from camera #1), and an overlay message, “SeaBotix LBV 150(300, 1500)”, briefly appears on-screen. This message is replaced by the standard overlay as described in the LBV User’s Manual.
• The overlay should appear so that the following conditions are met: Up, Down and Horizontal Thruster Gains all display “5”, The Heading display indicates a valid value (0-360/does not read ‘777’), The Date/Time stamp is correct and counting, The Depth reading is approximately 0 (+/-20MS/does not read777.7), and the Temperature reading is stable (not -9 deg C).
• The LBV shows the following indications: The Green Motherboard Communication LEDs are flashing @ 3 Hz, The Motherboard Red 12 and 5VDC power LEDs are continuously lit (with no flicker).
• The user is able to operate all LBV functions, i.e.: Operate thrusters in all directions, tilt the camera chassis, select and focus cameras, operate lamps, open/close grabber, etc.